11 lines
776 B
Plaintext
11 lines
776 B
Plaintext
Stepper Gantry basic configurations.
|
|
|
|
It is very important for gantry machines to set initial home switch positions before first homing so they reach home switches at a very similar time. To remove any skewing on the gantry adjust the home offset of one joint. After homing the configuration will switch from joint mode to world mode.
|
|
|
|
gantry_joints.ini uses the same .hal file but uses kinstype=BOTH which requires independently homing each joint axis.
|
|
|
|
gantry.ini implements a dual Y motor gantry. This is the configuration to use after you verify the directions and speeds of the individual joints using gantry_joints.ini.
|
|
|
|
These configs use switches for min-home on the X,Y,Y2 axis and max-home for Z. Pay attention to the parallel input pin assignment for the switches.
|
|
|