46 lines
2.0 KiB
Plaintext
46 lines
2.0 KiB
Plaintext
# HAL config file for using classic ladder
|
|
|
|
# The core_sim.hal file sets up motion, stepgen and other common items
|
|
# Remove core_sim.hal connections for the following pins and implement
|
|
# using classic latter functionality instead:
|
|
unlinkp iocontrol.0.user-enable-out
|
|
unlinkp iocontrol.0.emc-enable-in
|
|
|
|
# This file adds:
|
|
# the possibility of an external momentary or sustained NC estop button
|
|
# and includes intermittent lube pump and pressure or level sensing.
|
|
|
|
# (load the realtime portion)
|
|
# these classicladder parameters need to be optimized after ladder completion
|
|
loadrt classicladder_rt numRungs=12 numBits=20 numWords=4 numTimers=5 numMonostables=2 numPhysInputs=10 numPhysOutputs=10 numArithmExpr=4 numSections=4
|
|
# We kick ladder into a thread at the slower servo rate rather than base rate
|
|
addf classicladder.0.refresh servo-thread 1
|
|
|
|
# invoke the user part of CL to silently load the program
|
|
# later we will need to add the clp file mentioned below
|
|
# to the ini file so that we do not need to hardcode it here.
|
|
loadusr -w classicladder --nogui demo_sim_cl.clp
|
|
|
|
# three axis motion allows 6 other outputs on pins 8,9,1,14,16,17
|
|
# five additional input pins are available 10,11,12,13,15
|
|
# these are setup by the work they perform below
|
|
|
|
# estop signals
|
|
# signal is the internal or gui estop command from EMC
|
|
net gui-estop iocontrol.0.user-enable-out classicladder.0.in-00
|
|
# one-shot on timer when signal above goes high.
|
|
net estop-strobe iocontrol.0.user-request-enable classicladder.0.in-02
|
|
# this bit is an external estop button connected to parport pin 11 and ground
|
|
net ext-estop classicladder.0.in-01
|
|
# This bit signal is command to estop from CL to EMC
|
|
net estop-all-ok iocontrol.0.emc-enable-in classicladder.0.out-00
|
|
|
|
# lube signals
|
|
# lube run command from emc to CL
|
|
# for ease of reading we will make a new signal lube-run
|
|
net lube-run classicladder.0.out-01
|
|
|
|
# The lube sense stuff runs from an external pin, through CL to iocontrol in
|
|
# lube-up is the signal between the parport and cl
|
|
net lube-up classicladder.0.in-04
|