Import LinuxCNC source tree

tests/remap/fail/args.2/README

@@ -0,0 +1,3 @@
+Exercise failed parameter passing to user-defined code
+
+The required Q parameter is missing

tests/remap/fail/args.2/expected

@@ -0,0 +1,17 @@
+executing
+    1 N..... USE_LENGTH_UNITS(CANON_UNITS_MM)
+    2 N..... SET_G5X_OFFSET(1, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
+    3 N..... SET_G92_OFFSET(0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
+    4 N..... SET_XY_ROTATION(0.0000)
+    5 N..... SET_FEED_REFERENCE(CANON_XYZ)
+    6 N..... ON_RESET()
+user-defined M400: missing: P,Q
+O <rm400> call 
+    7 N..... SET_G5X_OFFSET(1, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
+    8 N..... SET_XY_ROTATION(0.0000)
+    9 N..... SET_FEED_MODE(0, 0)
+   10 N..... SET_FEED_RATE(0.0000)
+   11 N..... STOP_SPINDLE_TURNING(0)
+   12 N..... SET_SPINDLE_MODE(0 0.0000)
+   13 N..... PROGRAM_END()
+   14 N..... ON_RESET()

tests/remap/fail/args.2/rm400.ngc

@@ -0,0 +1,18 @@
+o<rm400> sub
+(debug, M400 call_level= #<_call_level> remap_level=#<_remap_level>)
+
+o100 if [EXISTS[#<P>]]
+     (debug, P word set: #<P>)
+o100 else
+     (debug, P word missing)
+o100 endif
+
+o120 if [EXISTS[#<Q>]]
+     (debug, Q word set: #<Q>)
+o120 else
+     (debug, Q word missing)
+o120 endif
+
+o<rm400> endsub
+m2
+%

tests/remap/fail/args.2/test.ini

@@ -0,0 +1,9 @@
+[EMC]
+DEBUG=0
+LOG_LEVEL=0
+
+[RS274NGC]
+SUBROUTINE_PATH = .
+
+# M405 requires P- Q- and does NOT permit any other words in this block
+REMAP=M400  modalgroup=5 argspec=PQ ngc=rm400

tests/remap/fail/args.2/test.ngc

@@ -0,0 +1,2 @@
+M400 R122.25
+M2

tests/remap/fail/args.2/test.sh

@@ -0,0 +1,3 @@
+#!/bin/bash
+rs274 -i test.ini -n 0 -g test.ngc 2>&1
+exit "${PIPESTATUS[0]}"