executing
    1 N..... USE_LENGTH_UNITS(CANON_UNITS_MM)
    2 N..... SET_G5X_OFFSET(1, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
    3 N..... SET_G92_OFFSET(0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
    4 N..... SET_XY_ROTATION(0.0000)
    5 N..... SET_FEED_REFERENCE(CANON_XYZ)
    6 N..... ON_RESET()
M500 P0 {
  active spindle:  0
  spindle speeds:  [0.0, 0.0, 0.0, 0.0, 0.0, 0.0, 0.0, 0.0]
}
    7 N..... SET_SPINDLE_SPEED(0, 1000.0000)
    8 N..... START_SPINDLE_CLOCKWISE(0)
M500 P1 {
  active spindle:  0
  spindle speeds:  [1000.0, 0.0, 0.0, 0.0, 0.0, 0.0, 0.0, 0.0]
}
    9 N..... SET_SPINDLE_SPEED(1, 2000.0000)
   10 N..... START_SPINDLE_COUNTERCLOCKWISE(1)
M500 P2 {
  active spindle:  0
  spindle speeds:  [1000.0, 2000.0, 0.0, 0.0, 0.0, 0.0, 0.0, 0.0]
}
   11 N..... SET_G5X_OFFSET(1, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
   12 N..... SET_XY_ROTATION(0.0000)
   13 N..... SET_FEED_MODE(0, 0)
   14 N..... SET_FEED_RATE(0.0000)
   15 N..... STOP_SPINDLE_TURNING(0)
   16 N..... SET_SPINDLE_MODE(0 0.0000)
   17 N..... STOP_SPINDLE_TURNING(1)
   18 N..... SET_SPINDLE_MODE(1 0.0000)
   19 N..... STOP_SPINDLE_TURNING(2)
   20 N..... SET_SPINDLE_MODE(2 0.0000)
   21 N..... PROGRAM_END()
   22 N..... ON_RESET()