N..... USE_LENGTH_UNITS(CANON_UNITS_MM)
 N..... SET_G5X_OFFSET(1, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
 N..... SET_G92_OFFSET(0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
 N..... SET_XY_ROTATION(0.0000)
 N..... SET_FEED_REFERENCE(CANON_XYZ)
 N..... ON_RESET()
 N..... COMMENT("Fanuc params have global scope; rs274ngc params #1..#30 have local scope ")
 MAIN/FANUC: PRE-M98: 1=42.010000; 30=42.300000; 31=42.310000
 O1: START: 1=42.010000; 30=42.300000; 31=42.310000
 O1: END: 1=13.010000; 30=13.300000; 31=13.310000
 MAIN/FANUC: POST-M98: 1=13.010000; 30=13.300000; 31=13.310000
 MAIN/RS274NGC: PRE-O-CALL: 1=42.010000; 30=42.300000; 31=42.310000
 O2: START: 1=0.000000; 30=0.000000; 31=42.310000
 O2: END: 1=13.010000; 30=13.300000; 31=13.310000
 MAIN/RS274NGC: POST-O-CALL: 1=42.010000; 30=42.300000; 31=13.310000
 N..... SET_G5X_OFFSET(1, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000, 0.0000)
 N..... SET_XY_ROTATION(0.0000)
 N..... SET_FEED_MODE(0, 0)
 N..... SET_FEED_RATE(0.0000)
 N..... STOP_SPINDLE_TURNING(0)
 N..... SET_SPINDLE_MODE(0 0.0000)
 N..... PALLET_SHUTTLE()
 N..... PROGRAM_END()
 N..... ON_RESET()
 N..... ON_RESET()