# sample file pulls all load commands into a single file

# kinematics
loadrt [KINS]KINEMATICS

#motion controller, get name and thread periods from ini file
loadrt [EMCMOT]EMCMOT servo_period_nsec=[EMCMOT]SERVO_PERIOD num_joints=[KINS]JOINTS

# next load the PID module, for four PID loops
loadrt pid num_chan=4

# install Universal PWM Controller driver
# if the parallel port the PPMC is connected to is not the standard 0x378, add
#  port_addr="0x1234" to the end of the following line, separated by a space
# on LinuxCNC versions 2.7.9 and above, a parameter allows you to change the
#    way the EPP port is controlled.  For PCIe cards using the NetMos 990x
#    chips, append epp_dir=1 to the end of the following line
loadrt hal_ppmc

# make some signals for the scope for tuning.
loadrt ddt count=4
loadrt estop_latch count=1
loadrt and2 count=1

# set up the realtime thread
# read inputs first
addf ppmc.0.read servo-thread
# then run the motion controller
addf motion-command-handler servo-thread
addf and2.0 servo-thread
addf estop-latch.0 servo-thread
addf motion-controller servo-thread
# then the PID loops
addf pid.0.do-pid-calcs servo-thread
addf pid.1.do-pid-calcs servo-thread
addf pid.2.do-pid-calcs servo-thread
addf pid.3.do-pid-calcs servo-thread
# write outputs last
addf ppmc.0.write servo-thread