按建议，继续工作

结论：扩大 WASM 解释器负向夹具和文件执行路径验证，聚合 host/WASM/OPFS/browser smoke 已通过。

wasm-port/docs/compatibility-validation.md

@@ -203,12 +203,15 @@ for `minimal_linear`, `arc_semantics`, `length_units`, `modal_incremental`,
 `nurbs_g5_semantics`, `nurbs_g6_semantics`, `state_tag_motion`,
 `canon_runtime_edges`, `program_end_modal_reset`, and `namedparam_semantics`,
 plus the `g1_zero_feed`, `arc_radius_mismatch`, `arc_zero_radius`,
-`g53_incremental`, `tool_not_found`, and `tool_length_offset_not_found`
+`cutter_comp_plane_change`, `g53_incremental`, `namedparam_readonly`,
-negative fixtures. The WASM interpreter file path additionally covers
+`numbered_param_readonly`, `tool_not_found`, and
-`file_open_reset`, `percent_file_finish`, and `oword_subroutine`. OPFS
+`tool_length_offset_not_found` negative fixtures. The WASM interpreter file
-validation is limited to the JavaScript host-boundary adapter plus the INI
+path additionally covers the same canonical-event fixture group except
-browser smoke harness. Full browser coverage, full SDK coverage, and full
+`namedparam_semantics` and `position_params`, plus `file_open_reset`,
-machine-session validation remain future work.
+`percent_file_finish`, and `oword_subroutine`. OPFS validation is limited to
+the JavaScript host-boundary adapter plus the INI browser smoke harness. Full
+browser coverage, full SDK coverage, and full machine-session validation remain
+future work.
 
 The current fixture expectations validate standalone behavior against both the
 vendored LinuxCNC source path and an upstream `rs274` side-by-side baseline for

wasm-port/tests/wasm/node/verify_interp_wasm.mjs

@@ -167,7 +167,10 @@ const errorFixtureNames = [
   "g1_zero_feed",
   "arc_radius_mismatch",
   "arc_zero_radius",
+  "cutter_comp_plane_change",
   "g53_incremental",
+  "namedparam_readonly",
+  "numbered_param_readonly",
   "tool_not_found",
   "tool_length_offset_not_found",
 ];
@@ -186,6 +189,29 @@ for (const fixtureName of errorFixtureNames) {
 }
 
 const fileFixtureNames = [
+  "minimal_linear",
+  "arc_semantics",
+  "length_units",
+  "modal_incremental",
+  "plane_selection",
+  "coordinate_offsets",
+  "g53_machine_coordinates",
+  "feed_control_modes",
+  "probe_semantics",
+  "spindle_orient",
+  "comment_logging",
+  "numbered_params",
+  "tool_semantics",
+  "tool_table_setup",
+  "tool_reload",
+  "canned_cycles",
+  "cutter_comp_motion",
+  "threading_sync",
+  "nurbs_g5_semantics",
+  "nurbs_g6_semantics",
+  "state_tag_motion",
+  "canon_runtime_edges",
+  "program_end_modal_reset",
   "file_open_reset",
   "percent_file_finish",
   "oword_subroutine",